I found selecting “CAT (Voice port)” also works.Įnabling FT8/PSK reporting to /pskmapįT-8 PSK Reporter map on 20 m using Diamon CP-6.įT-8 PSK Reporter map on 40 m using Diamon CP-6.įT-8 PSK Reporter map on multiple bands using Diamon CP-6. This seems the be a unrelated bug in QSSTV: Floating point exception (core dumped)
Sometimes the software would occasionally crash with the following error in console. It tees the audio so you can also access the audio source on the host machine at the same time. Here is an example of the VirtualBox audio being used to pass audio into MMSSTV inside a Windows VM. You can pass inputs in seamlessly without the need for USB pass-through. If using a Linux host you can pass audio into a Windows VirtualBox VM for Windows only software data modes. The “SET” button allows for resume times etc. Scan function “ΔF (Delta Frequency)” can do + or - 1 MHz max freq sweep. Instead switch “DATA OFF MOD” as required from “MIC,ACC” to “USB”. Probably don’t bother with using the “DATA” mode as its too narrow AF output for SSTV etc. So you can switch “ACC/USB Output Select” to IF and AF output depending if you need raw IQ or standard speaker audio into your software.
“DATA” mode seems to allow audio input via USB instead of using the microphone it also seems to change the RX bandwidth to a very small 1.2k or 500 and remove DSP. “ACC” is the accessory socket aka DIN socket. This is to allow USB audio to always be present regardless of SQL level. “SET”/”Connectors”/”USB Audio SQL”: “OFF (OPEN)” This is to choose USB source as the microphone when operating in “DATA” mode.
This is to choose fist microphone when not operating in “DATA” mode e.g. vertaald door Fontenoy Rudy ON4CKT, 30 september 2020 Icom IC-705 10W HF/6m/2m/70cm Portable Transceiver 1299.95 Free Shipping Limit of 2 per customer. “SET”/”Connectors”/”DATA OFF MOD”: “MIC,ACC” “IF” (Intermediate Frequency) is basically raw IQ. “AF” is basically normal speaker audio without much/any DSP. I was at the Orlando Hamvention where I first saw the IC-7100 on display. My IC-7000 DC DC convertor failed a year ago, and with nobody to repair it in my country, I decided to buy an IC-7100 as a replacement. “SET”/”Connectors”/”ACC/USB Output Select”: “AF” for data modes direct and “IF” for anything via GQRX. I have owned many IC-706MK2G rigs (I still have one), and I have had about 5 x IC-7000 rigs (I still have one). Using IC-7100 for data modes on a PC Connector settings explained